-
Q: What is the primary function of the 330103-00-02-10-02-05 probe?
A: It measures shaft displacement and vibration in rotating equipment, providing data to protect machinery from excessive movement and wear.
-
Q: What wiring connector does this probe use?
A: The probe features a standard 4-pin LEMO connector compatible with 3300 XL series monitoring systems.
-
Q: How do I mount the probe?
A: Install the probe body into a threaded boss on the machine casing and secure with the locknut; align perpendicular to the shaft.
-
Q: Can it withstand harsh chemicals?
A: Yes. The stainless-steel housing and PFA-jacketed cable resist oils, chemicals, and solvents commonly found in industrial environments.
-
Q: What maintenance is required?
A: Inspect the cable and connector annually for wear; clean the tip with alcohol to remove buildup. No internal calibration needed.
-
Q: What resolution can I expect?
A: Typical resolution is 0.001 mm, enabling detection of nanometer-scale changes in shaft position.
-
Q: Is the probe explosion-proof?
A: While the probe itself is not certified explosion-proof, it can be used in hazardous areas when installed within an approved housing or conduit.
-
Q: What happens if the cable is over-bent?
A: The shielded coaxial cable is designed for flexing, but sharp bends (< 50 mm radius) should be avoided to maintain signal integrity.
-
Q: How do I verify proper operation?
A: Use the 3300 XL monitor’s built-in test function to sweep the probe and confirm linear response and signal strength.
-
Q: Can I extend the cable length?
A: Yes, by using Bently Nevada’s certified extension cables (e.g., 330180-00-02-10-02-00) without signal loss up to 10 meters.
